Product Description
TH95112 Toyota Corolla 1993-1997 Sedan Full Rocker Kit, 9"-10" Tapered, 8 Pieces
TH95112 is an eight-piece polished stainless steel Full Kit for the 1993-1997 Toyota Corolla 4-door sedan. It "Spans from the bottom of the molding to the bottom of the door," and the width is listed as "9" - 10" tapered." It is listed for the 1993-1997 Corolla sedan.
Nine to ten inches
Each piece runs from 9" at one end to 10" at the other, a taper of a full inch. The record doesn't say which end is taller. Your own measurements are what tell you.
Measuring a tapered gap
Measure from the lower edge of the molding to the door bottom near the front, middle and rear of each door. Sketch the car and write the numbers on it. Readings that sit between 9" and 10" and change along the door are what the listing describes. If they don't, call 877-752-3811 with the sketch.
Pillar sets
Two Pillar Post Trim sets are linked for this Corolla: PP97112 with four pieces and PP97113 with six. The record doesn't say how they differ beyond the count.
Material
Cut in the USA from polished 26 gauge 304 stainless, the eight tapered 1993-1997 Corolla pieces bond between molding and door bottom with 3M automotive-grade acrylic foam tape. QAA states the tape will hold for a lifetime without damaging the Toyota.
A lot of paint under tape
With up to 10" of height per piece, a large area of paint will be covered. Clean all of it: soapy wash, wax-and-grease remover, repairs to chips or rust, then an alcohol wipe just before fitting.
Molding
The top edge of each piece rides against the molding. Check it's firm along all four doors and repair any lifting sections first.
Orientation
During the dry fit, match each piece's taller end to the taller part of the gap. If a piece fits better reversed, stop and check.
Eight pieces
The record doesn't list positions. Label each liner with position and direction.
Bonding
Peel a few inches of liner, press across the full height, and continue. Finish with firm pressure.
Corolla pieces after the first door
Keep the Corolla spacing and taper direction consistent on every piece.
Weather
Fit the Corolla on a mild, dry day in shade, then skip washing for a day.
If the molding is damaged
A cracked, loose or missing section of molding leaves a piece with nothing to meet at the top. Repair it before ordering, and send a photo of each side if you are unsure.
A replaced door
If one door or its molding has been replaced, its readings can differ from the pattern. Measure it on its own and tell us which door it is.
One door first
Fit one door completely, step back and look along the side, then carry on. Lay the pieces on a soft towel while sorting so the polished faces stay unmarked.
Keep every liner on until all four doors are dry fitted.
With your year and readings, call Quality Automotive Trims at 877-752-3811 about Corolla kit TH95112, UPC 691821676033.
TH95112 specifications
| Brand | QAA |
|---|---|
| Part number (MPN) | TH95112 |
| UPC | 691821676033 |
| Part type | Rocker Panel Trim, Full Kit |
| Pieces in kit | 8 |
| Material | Polished 26-gauge 304 stainless steel |
| Finish | Polished to a mirror shine |
| Width | 9" to 10" tapered |
| Coverage / notes | Spans from the bottom of the molding to the bottom of the door |
| Mounting | 3M automotive-grade acrylic foam tape; installs directly over the existing surface |
| Origin | Made in the USA |
| Fits | 1993-1997 Toyota Corolla |
Fitment: TH95112
| Vehicle | Years | Body style |
|---|---|---|
| Toyota Corolla | 1993-1997 | 4-door, Sedan |
Fitment is listed exactly as QAA catalogs it. Confirm the body style as well as the year and model. Questions? Call Quality Automotive Trims at 877-752-3811 with your year, make, model, and body style.
Other QAA trim cataloged for the 1993-1997 Toyota Corolla
Check the body style on each listing; some kits are specific to one body style.
Installation tips: Rocker Panel Trim, Full Kit
- Unpack all 8 pieces and match each one to its position on the vehicle, using the product photos, before fitting any of them.
- Each piece mounts with 3M automotive-grade acrylic foam tape, so clean and dry the mounting surface first; the tape needs paint or trim free of dirt and wax.
- Align the piece and press it firmly into place directly over the existing surface, working along its full length so the tape bonds evenly.
- Fit one piece at a time and compare each with the product photos and the pieces already in place.
These are general tips. Follow any instructions packed with your kit if they differ.
FAQ: TH95112 Rocker Panel Trim, Full Kit
Which Corolla does TH95112 fit?
The 1993-1997 Toyota Corolla 4-door sedan.
How wide is it?
Tapered, 9" to 10", molding to door bottom.
Are there pillar sets?
PP97112 (4 pieces) & PP97113 (6 pieces) are linked.
How many pieces?
Eight.
