Product Description
Subaru Legacy & Outback Wagon 1994-1999 Upper Rocker Kit TH95445, 3.625", 8 Pieces
TH95445 is an eight-piece polished stainless steel Upper Kit listed for the 1994-1999 Subaru Legacy and the Subaru Outback Wagon of the same years. It "Spans from the bottom of the molding DOWN to the specified width," and the width is 3.625".
Two body rows
The record carries two fitment rows, each naming both the Legacy and the Outback Wagon: one tagged "4-door, Sedan," the other "4-door, Outback Wagon." It gives one width and one piece count for all of them. It doesn't say whether a Legacy wagon that isn't an Outback is covered, so if that's your car, call 877-752-3811 first.
A slim band
3.625" (just over three and a half inches) below the molding is a narrow strip. It leaves the rest of the lower door uncovered. To see where its lower edge will fall, run masking tape at that depth along all four doors and look from a few paces back.
No length note
The record doesn't say whether the eight pieces stop at the wheel wells or continue. The product photos show the layout.
Material
Legacy and Outback Wagon owners get eight 3.625" strips that QAA forms in the USA out of polished 26 gauge 304 stainless, secured over the existing surface with 3M automotive-grade acrylic foam tape. QAA states the tape will hold for a lifetime without harming the 1994-1999 Subaru.
Why the molding matters
Every piece's top edge sits right under the molding. On a narrow strip, any wave in the molding shows straight away in the trim line. Check it on all four doors and refit or repair anything that has lifted.
Clean band, good bond
- Wash under the Legacy or Outback molding with soapy water and rinse
- Wax-and-grease remover across the strip
- Touch-up for any chips
- An alcohol wipe on each spot as its piece goes on
Sorting eight pieces
The record doesn't list positions. Lay the pieces on a soft towel, compare them with the photos, and label each liner.
Dry fit
Tape each piece up with painter's tape, top edge snug against the molding. Narrow strips show any tilt, so sight along the side from both ends and adjust before you peel anything. Open all four doors.
Pressing on
Peel the liner a few inches at a time and press firmly as you go, then press the whole piece again.
Legacy and Outback joints
Hold the Subaru's gaps to one consistent size.
Weather
Shaded, mild and dry; wash the Subaru a day later at the earliest.
Before ordering
Tell us the model (Legacy or Outback Wagon), year and body. Keep the box until the job is done.
The other Outback listing
QAA also has an Impreza listing that names an Outback Wagon, with a wider band and a longer year range. It isn't linked here. If you have an Outback Wagon, ask us which of the two applies before ordering.
Do a single door first and look at the line from a few paces away.
Leave all liners in place until the dry fit covers all four doors.
For Legacy and Outback kit TH95445, the UPC is 691821366323 and the number is 877-752-3811.
TH95445 specifications
| Brand | QAA |
|---|---|
| Part number (MPN) | TH95445 |
| UPC | 691821366323 |
| Part type | Rocker Panel Trim, Upper Kit |
| Pieces in kit | 8 |
| Material | Polished 26-gauge 304 stainless steel |
| Finish | Polished to a mirror shine |
| Width | 3.625" |
| Coverage / notes | Spans from the bottom of the molding DOWN to the specified width |
| Mounting | 3M automotive-grade acrylic foam tape; installs directly over the existing surface |
| Origin | Made in the USA |
| Fits | 1994-1999 Subaru Legacy and 1994-1999 Subaru Outback Wagon |
Fitment: TH95445
| Vehicle | Years | Body style |
|---|---|---|
| Subaru Legacy | 1994-1999 | 4-door, Sedan |
| Subaru Outback Wagon | 1994-1999 | 4-door, Sedan |
| Subaru Legacy | 1994-1999 | 4-door, Outback Wagon |
| Subaru Outback Wagon | 1994-1999 | 4-door, Outback Wagon |
Match the year, model, and body style in this table to your vehicle before ordering. Questions? Call Quality Automotive Trims at 877-752-3811 with your year, make, model, and body style.
Installation tips: Rocker Panel Trim, Upper Kit
- Unpack all 8 pieces and match each one to its position on the vehicle, using the product photos, before fitting any of them.
- Each piece mounts with 3M automotive-grade acrylic foam tape, so clean and dry the mounting surface first; the tape needs paint or trim free of dirt and wax.
- Align the piece and press it firmly into place directly over the existing surface, working along its full length so the tape bonds evenly.
- Fit one piece at a time and compare each with the product photos and the pieces already in place.
These are general tips. Follow any instructions packed with your kit if they differ.
FAQ: TH95445 Rocker Panel Trim, Upper Kit
Does TH95445 fit the Outback Wagon?
The fitment lists the 1994-1999 Subaru Outback Wagon alongside the Legacy.
Where does it install?
From the bottom of the molding down 3.625".
Does it fit the Legacy sedan?
Yes, one fitment row is tagged 4-door sedan.
How many pieces?
Eight.
