Product Description
Chevrolet Tahoe 2007-2008 Side Molding Insert Kit, 2.187", 6 Pieces (TH47195)
TH47195 is a six-piece Insert Kit for the Chevrolet Tahoe four-door SUV from 2007 to 2008. The polished stainless steel inserts are 2.187" wide and the record's placement note is "Side Molding."
Two years, no siblings
The fitment covers just 2007 and 2008, and nothing is linked to this record. A separate Tahoe record in the catalog, a four-piece 1" Lower Kit for the doors, runs over a longer span; it isn't linked here, and the data doesn't say whether the two can be combined. If your Tahoe is newer than 2008, this insert record doesn't list it.
Same width as another insert kit
The catalog also has a six-piece, 2.187" insert kit listing the Avalanche and Suburban for the same two years. It isn't linked to this one either. If you're comparing them, call 877-752-3811.
Six pieces on four doors
The data doesn't explain the split. Match each insert to the product photos, group them by door, and number the liners. Ask if the photos don't settle it.
Check the molding
These go onto the side molding, so the strips must be on the Tahoe and firmly attached. Measure the face; it should be close to 2.187", which is about two and three-sixteenths inches. If the molding is missing or different on some doors, send a photo before ordering.
Material
The six 2007-2008 Tahoe inserts are USA-made, polished 26 gauge 304 stainless steel. They are applied over the existing side molding with 3M automotive-grade acrylic foam tape. According to QAA, the tape will hold for a lifetime without damage.
Prep
Wash, rinse and dry the strips. Then go over each one with isopropyl alcohol.
Install
- Center each Tahoe insert on its strip using painter's tape.
- Check both ends and the line along the door.
- Peel a short section of liner and set that end.
- Press along as the liner comes away, then firmly over everything.
Across the doors
Inserts meeting at a door gap should sit at the same height.
After
Swing every door open to make sure nothing rubs. After a day, clean the Tahoe inserts with mild soap and a soft mitt.
Weather
Do the Tahoe in dry, mild weather or a garage.
Before ordering
Tahoe four-door, 2007 or 2008, molding on every door at about 2.187". If all of that matches, this record fits.
What to send if you call
Send the year, a picture of one full side, and a close shot of the molding with a ruler held across it.
A helper
Someone holding the far end of each insert keeps it centered while you set the near end.
Molding condition
Press along each strip with your fingertips. If a section moves, lifts at an end or has a crack, re-secure or repair it before installing; the steel can only sit as flat as the strip beneath it. The kit doesn't include molding.
Tahoe inserts, measured
Measure the first inserts from the door edges, then place the rest to those measurements.
For the Tahoe insert kit TH47195 (UPC 691821545384), call 877-752-3811.
TH47195 specifications
| Brand | QAA |
|---|---|
| Part number (MPN) | TH47195 |
| UPC | 691821545384 |
| Part type | Rocker Panel Trim, Insert Kit |
| Pieces in kit | 6 |
| Material | Polished 26-gauge 304 stainless steel |
| Finish | Polished to a mirror shine |
| Width | 2.187" |
| Coverage / notes | Side Molding |
| Mounting | 3M automotive-grade acrylic foam tape; installs directly over the existing surface |
| Origin | Made in the USA |
| Fits | 2007-2008 Chevrolet Tahoe |
Fitment: TH47195
| Vehicle | Years | Body style |
|---|---|---|
| Chevrolet Tahoe | 2007-2008 | 4-door, SUV |
Check your vehicle against every column here: year range, model, and body style all have to match. Questions? Call Quality Automotive Trims at 877-752-3811 with your year, make, model, and body style.
Installation tips: Rocker Panel Trim, Insert Kit
- Unpack all 6 pieces and match each one to its position on the vehicle, using the product photos, before fitting any of them.
- Each piece mounts with 3M automotive-grade acrylic foam tape, so clean and dry the mounting surface first; the tape needs paint or trim free of dirt and wax.
- Align the piece and press it firmly into place directly over the existing surface, working along its full length so the tape bonds evenly.
- Fit one piece at a time and compare each with the product photos and the pieces already in place.
These are general tips. Follow any instructions packed with your kit if they differ.
FAQ: TH47195 Rocker Panel Trim, Insert Kit
What does TH47195 fit?
The Chevrolet Tahoe four-door SUV, 2007-2008.
Where do the inserts go?
On the side molding. They're 2.187" wide.
How many pieces?
Six. The record doesn't say how they split by door.
Does it fit a newer Tahoe?
This record covers 2007-2008 only. Call 877-752-3811.
