Product Description
Nissan Altima 1993-1996 Sedan Full Kit TH93550, 6"-6.75", 8 Pieces
TH93550 is an eight-piece Full Kit in polished stainless steel for the 1993-1996 Nissan Altima 4-door sedan. It "Spans from the bottom of the molding to the bottom of the door," and the width bullet reads "6" - 6.75" Width."
A range, not a taper?
The bullet gives two figures but doesn't use the word "tapered." The record doesn't say whether 6" to 6.75" describes a taper along each piece, a difference between pieces, or a tolerance. Since we can't tell from the record, please do two things before ordering: look closely at the product photos, and measure your own car.
Measuring the Altima
- Use a rigid ruler, square to the panel
- Measure down from the bottom of the Altima's molding to the door's lower edge
- Take a reading near the front, middle and back of every door
- Note any door where the reading changes along its length
Readings between 6" and 6.75" are what the listing describes. Send them to 877-752-3811 if any fall outside that, or if you're unsure how the range applies.
Eight pieces
The record doesn't list positions on the four doors. Lay the pieces out, compare them with the photos, and if any are taller at one end, note the orientation on the liner.
What they're made from
Nissan's 1993-1996 Altima gets eight tapered pieces of polished 26 gauge 304 stainless steel, cut in the USA and secured from the molding to the door bottom with 3M automotive-grade acrylic foam tape. QAA states the tape will hold for a lifetime without harming the sedan.
No linked parts
Nothing else is linked to this record, so it's the single Altima rocker listing here.
Ready to fit
Run a hand along the molding on each door to check it's firm. Wash the band below it, take off old wax with a wax-and-grease remover, repair chips, and give it a final alcohol wipe.
Dry fit, then stick
Tape each piece up with painter's tape so it meets the molding at the top and the door bottom at the base. Open each door. When the layout matches the photos, peel the liner a little at a time and press down firmly.
After the first doors
Hold the gaps to one size throughout.
Day and weather
A mild, dry day out of direct sun. Hold off washing for a day.
If a door reads differently
If one door gives readings that don't fit the pattern of the others, check whether it or its molding has been replaced, and give us each door's readings separately.
Pace
Fit a single door completely, then step back and look along the side from the front and rear. Repositioning is easy while the liner is still on. Lay the pieces on a soft towel while you sort them so the polished faces stay unmarked.
Keep every liner on until all four doors are dry fitted and the layout matches the photos.
Have your readings ready for 877-752-3811 when asking about 1993-1996 Altima set TH93550 (UPC 691821694198).
TH93550 specifications
| Brand | QAA |
|---|---|
| Part number (MPN) | TH93550 |
| UPC | 691821694198 |
| Part type | Rocker Panel Trim, Full Kit |
| Pieces in kit | 8 |
| Material | Polished 26-gauge 304 stainless steel |
| Finish | Polished to a mirror shine |
| Width | 6-6.75" |
| Coverage / notes | Spans from the bottom of the molding to the bottom of the door |
| Mounting | 3M automotive-grade acrylic foam tape; installs directly over the existing surface |
| Origin | Made in the USA |
| Fits | 1993-1996 Nissan Altima |
Fitment: TH93550
| Vehicle | Years | Body style |
|---|---|---|
| Nissan Altima | 1993-1996 | 4-door, Sedan |
Match the year, model, and body style in this table to your vehicle before ordering. Questions? Call Quality Automotive Trims at 877-752-3811 with your year, make, model, and body style.
Installation tips: Rocker Panel Trim, Full Kit
- Unpack all 8 pieces and match each one to its position on the vehicle, using the product photos, before fitting any of them.
- Each piece mounts with 3M automotive-grade acrylic foam tape, so clean and dry the mounting surface first; the tape needs paint or trim free of dirt and wax.
- Align the piece and press it firmly into place directly over the existing surface, working along its full length so the tape bonds evenly.
- Fit one piece at a time and compare each with the product photos and the pieces already in place.
These are general tips. Follow any instructions packed with your kit if they differ.
FAQ: TH93550 Rocker Panel Trim, Full Kit
Which Altima does TH93550 fit?
The 1993-1996 Nissan Altima 4-door sedan.
Is the 6"-6.75" width a taper?
The record doesn't say. Check the photos or call 877-752-3811.
Where does it install?
From the bottom of the molding to the bottom of the door.
How many pieces?
Eight.
