Product Description
Nissan Sentra 1996-1997 Sedan Full Rocker Kit TH95575, 8"-8.75" Tapered, 8 Pieces
TH95575 is an eight-piece polished stainless steel Full Kit for the Nissan Sentra 4-door sedan, listed for 1996-1997. The fitment line says "also fits 1995 1/2 as well," so a mid-1995 sedan is named too. The pieces span "from the bottom of the molding to the bottom of the door" at a tapered 8" to 8.75".
The 1995 1/2 note
The title says 1996-1997, while the fitment note extends to the 1995 1/2 sedan. The record doesn't explain how to tell a 1995 1/2 car from an earlier 1995. If yours is a 1995, measure it as described below and call 877-752-3811 with the readings and, if you have it, the build date from the door jamb label.
Reading a taper
The listed width runs from 8" to 8.75", so the space between molding and door bottom isn't the same everywhere. The record doesn't say which end is taller. Measure at the front and rear of each door with a rigid ruler square to the panel and write the figures down. Readings inside 8" to 8.75" agree with the listing; anything outside that range, call us first.
Material and mounting
- Sentra steel: high-quality polished 304, 26 gauge
- Built in the USA for the Sentra
- Attaches over the Sentra's current surface with 3M automotive-grade acrylic foam tape
QAA says the tape fixing the eight 1996-1997 Sentra sedan pieces will hold for a lifetime without causing any damage to the Nissan.
Molding first
Every piece meets the molding along its top edge. If a section is loose, bent or missing, sort it out before fitting, since the trim follows whatever line the molding sets.
Surface preparation
The tape covers most of the lower door at this height. Wash and rinse, go over the whole area with a wax-and-grease remover, treat any chips or rust spots, let them dry, and wipe with isopropyl alcohol right before the first piece goes on.
Placing eight pieces
Positions aren't given in the record. Lay the set out, compare shapes with the photos, and mark each liner. Because of the taper, a piece turned end for end won't follow the door edge, which makes the right way round easy to spot when you hold it up.
Trial fit
- Painter's-tape every piece into place.
- Check both the molding edge and the door bottom edge.
- Open each door to confirm clearance.
- Look down the Sentra from front and back.
Bonding
Peel a short length of liner, press across the full height, and keep going. Finish with firm hand pressure along each edge.
Weather
Fit on a mild, dry day in shade, and leave the car unwashed for a day.
If the readings are mixed
Doors can read inside the range or just outside it, especially after a repair. Note which door gave which figure and share them all when you call.
Keep the pieces flat in the box until you're ready to sort them.
1996-1997 Sentra kit TH95575 is listed under UPC 691821563920; Quality Automotive Trims answers at 877-752-3811.
TH95575 specifications
| Brand | QAA |
|---|---|
| Part number (MPN) | TH95575 |
| UPC | 691821563920 |
| Part type | Rocker Panel Trim, Full Kit |
| Pieces in kit | 8 |
| Material | Polished 26-gauge 304 stainless steel |
| Finish | Polished to a mirror shine |
| Width | 8" to 8.75" tapered |
| Coverage / notes | Spans from the bottom of the molding to the bottom of the door |
| Mounting | 3M automotive-grade acrylic foam tape; installs directly over the existing surface |
| Origin | Made in the USA |
| Fits | 1996-1997 Nissan Sentra |
Fitment: TH95575
| Vehicle | Years | Body style |
|---|---|---|
| Nissan Sentra | 1996-1997 | 4-door, Sedan, also fits 1995 1/2 as well, |
Match the year, model, and body style in this table to your vehicle before ordering. Questions? Call Quality Automotive Trims at 877-752-3811 with your year, make, model, and body style.
Installation tips: Rocker Panel Trim, Full Kit
- Unpack all 8 pieces and match each one to its position on the vehicle, using the product photos, before fitting any of them.
- Each piece mounts with 3M automotive-grade acrylic foam tape, so clean and dry the mounting surface first; the tape needs paint or trim free of dirt and wax.
- Align the piece and press it firmly into place directly over the existing surface, working along its full length so the tape bonds evenly.
- Fit one piece at a time and compare each with the product photos and the pieces already in place.
These are general tips. Follow any instructions packed with your kit if they differ.
FAQ: TH95575 Rocker Panel Trim, Full Kit
Which Sentra does TH95575 fit?
The 1996-1997 Nissan Sentra 4-door sedan; the fitment also names the 1995 1/2 sedan.
How do I know if my 1995 is a 1995 1/2?
The record doesn't say. Call 877-752-3811 with your measurements & build date.
How wide is it?
8" to 8.75", tapered.
How many pieces?
Eight.
