Product Description
TH95590 Nissan Sentra 200SX Coupe 1995-1996 Full Rocker Kit, 8.25"-8.5" Tapered, 6 Pieces
TH95590 is a six-piece polished stainless steel Full Kit listed under the Nissan Sentra for 1995-1996, with the fitment restricted to the 2-door coupe and marked "200SX only". The pieces span "from the bottom of the molding to the bottom of the door," at a tapered 8.25" to 8.5".
200SX only
The title and the fitment line both limit this kit to the Sentra 200SX coupe. It isn't listed for the Sentra sedan. If you aren't sure which body you have, or the badging on your car doesn't match, call 877-752-3811 before ordering.
A narrow taper
The width moves only a quarter inch, from 8.25" to 8.5". The record doesn't say which end is taller. Measure from the bottom of the molding to the bottom of the door at the front and rear of each door. Readings within that range match the listing.
Construction
The six tapered 200SX coupe pieces are polished 26 gauge 304 stainless steel produced in the USA, and each is set between the molding and the door bottom with 3M automotive-grade acrylic foam tape. According to QAA, the tape will hold for a lifetime without damaging the 1995-1996 Nissan.
Six pieces
The record doesn't list where each of the six pieces goes. Sort them using the photos, and label each liner with its position before you start. Hold any piece you can't place and give us a call.
Getting the surface ready
- Wash the Sentra's lower door and rinse
- Lift wax off with a wax-and-grease remover
- Repair chips and rust spots
- Alcohol-wipe each Sentra door at the moment of fitting
Molding condition
The top of each piece sits against the molding. A lifting or broken section should be repaired first, because the trim can only be as straight as the line it follows.
Dry fit
Tape a run of pieces in place with painter's tape. Open and close the door, check both edges, and look along the side from front and back. Adjust until the joints are even.
Bonding
Peel the liner in short lengths, press each section, and then go over the whole piece with firm pressure. Use the first gaps as a guide for the rest.
Working conditions
Choose a mild, dry day out of direct sun. Give the tape a day before washing.
Before ordering
Take your two measurements per door, confirm the car is the 200SX coupe, and compare with 8.25" to 8.5". That's all it takes to be confident in the order.
After fitting
Check the edges again the next day and press down any spot that looks raised. Clean the polished face with a soft cloth and a mild cleaner rather than anything abrasive.
Hold on to the packaging until every piece is on and checked, in case one needs to be compared or swapped.
A second pair of hands makes holding a long piece level much easier.
Sentra set TH95590 has six pieces and UPC 691821517237; phone 877-752-3811 with questions.
TH95590 specifications
| Brand | QAA |
|---|---|
| Part number (MPN) | TH95590 |
| UPC | 691821517237 |
| Part type | Rocker Panel Trim, Full Kit |
| Pieces in kit | 6 |
| Material | Polished 26-gauge 304 stainless steel |
| Finish | Polished to a mirror shine |
| Width | 8.25" to 8.5" tapered |
| Coverage / notes | Spans from the bottom of the molding to the bottom of the door |
| Mounting | 3M automotive-grade acrylic foam tape; installs directly over the existing surface |
| Origin | Made in the USA |
| Fits | 1995-1996 Nissan Sentra |
Fitment: TH95590
| Vehicle | Years | Body style |
|---|---|---|
| Nissan Sentra | 1995-1996 | 2-door, Coupe, 200SX only |
Fitment is listed exactly as QAA catalogs it. Confirm the body style as well as the year and model. Questions? Call Quality Automotive Trims at 877-752-3811 with your year, make, model, and body style.
Installation tips: Rocker Panel Trim, Full Kit
- Unpack all 6 pieces and match each one to its position on the vehicle, using the product photos, before fitting any of them.
- Each piece mounts with 3M automotive-grade acrylic foam tape, so clean and dry the mounting surface first; the tape needs paint or trim free of dirt and wax.
- Align the piece and press it firmly into place directly over the existing surface, working along its full length so the tape bonds evenly.
- Fit one piece at a time and compare each with the product photos and the pieces already in place.
These are general tips. Follow any instructions packed with your kit if they differ.
FAQ: TH95590 Rocker Panel Trim, Full Kit
Which car does TH95590 fit?
The 1995-1996 Nissan Sentra 2-door coupe, 200SX only.
Does it fit the Sentra sedan?
It isn't listed for the sedan.
How wide is it?
8.25" to 8.5", tapered.
How many pieces?
Six.
