Product Description
Toyota Sienna 2004-2010 Lower Door Trim With Crease, 2.25", Eight Pieces (TH24150)
On a 2004-2010 Toyota Sienna, TH24150 puts a 2.25" band of polished stainless steel along the bottom of the doors. It's an eight-piece Lower Kit with two notes, "With trim crease" and "Spans from the bottom of the door UP to the specified width."
Minivan doors
The listing tags the Sienna as a 4-door minivan. The record doesn't explain how eight pieces are split across its doors and panels, so sort them using the product photos. If anything isn't clear, call 877-752-3811 before peeling a liner.
The crease
The note mentions a trim crease but doesn't describe it. Compare the photos with your lower doors before ordering.
Fitment
Toyota Sienna, 2004, 2005, 2006, 2007, 2008, 2009 and 2010.
Pillar kits for this Sienna
PP24150 (four pieces), PP24151 (six pieces) and PP24152 (eight pieces, which "Includes Rear Triangle piece") are linked. Check each listing for its finish.
Material and adhesive
The Sienna's eight creased pieces are polished 26 gauge 304 stainless, made in the USA, attached to the existing surface with 3M automotive-grade acrylic foam tape. Per QAA, the tape will hold for a lifetime without damaging the minivan.
Measure
Hold a ruler at the bottom of each door and mark two and a quarter inches. Check the band beneath the mark for dents, chips or anything in the way.
Clean
Wash the lower doors and dry them, including the bottom edges. Repair chips and let them cure. Wipe the band with isopropyl alcohol and let it flash off.
A sliding-door tip
If your Sienna has sliding doors, run each one fully open and closed with its piece held in place (liner on) before you peel anything, to make sure the ends clear.
Install
Rest each piece on the bottom edge of its door, liner on, and check the ends. Peel a short section, press firmly, and continue along the piece.
Even joints on the Sienna
Measure joint positions from the wheel openings as you place pieces and keep them consistent.
Supplies
Soap, touch-up paint if needed, isopropyl alcohol, lint-free cloths, painter's tape, a ruler.
Conditions and care
Install on a warm, dry day. Wait about a day before washing. Rinse salt off the lower doors and use only a non-abrasive polish.
Labeling eight pieces
With eight pieces on a long minivan side, labels save time. Put a strip of painter's tape on each liner with its position and its order front to back, based on the photos, before you clean anything.
What it changes
A two-and-a-quarter-inch strip of polished steel low on the doors gives a bright line along the whole side without changing anything else on the van.
Before ordering
Have your model year and a quick measurement of the flat band at the bottom of the doors ready if you call 877-752-3811. Mention any body repair along the lower doors, too.
Tip: press each piece again by hand after an hour.
The eight 2.25-inch Sienna pieces are TH24150, UPC 691821328970; Quality Automotive Trims takes calls at 877-752-3811.
TH24150 specifications
| Brand | QAA |
|---|---|
| Part number (MPN) | TH24150 |
| UPC | 691821328970 |
| Part type | Rocker Panel Trim, Lower Kit |
| Pieces in kit | 8 |
| Material | Polished 26-gauge 304 stainless steel |
| Finish | Polished to a mirror shine |
| Width | 2.25" |
| Coverage / notes | With trim crease; Spans from the bottom of the door UP to the specified width |
| Mounting | 3M automotive-grade acrylic foam tape; installs directly over the existing surface |
| Origin | Made in the USA |
| Fits | 2004-2010 Toyota Sienna |
Fitment: TH24150
| Vehicle | Years | Body style |
|---|---|---|
| Toyota Sienna | 2004-2010 | 4-door, Minivan |
Fitment is listed exactly as QAA catalogs it. Confirm the body style as well as the year and model. Questions? Call Quality Automotive Trims at 877-752-3811 with your year, make, model, and body style.
Other QAA trim cataloged for the 2004-2010 Toyota Sienna
Check the body style on each listing; some kits are specific to one body style.
Installation tips: Rocker Panel Trim, Lower Kit
- Unpack all 8 pieces and match each one to its position on the vehicle, using the product photos, before fitting any of them.
- Each piece mounts with 3M automotive-grade acrylic foam tape, so clean and dry the mounting surface first; the tape needs paint or trim free of dirt and wax.
- Align the piece and press it firmly into place directly over the existing surface, working along its full length so the tape bonds evenly.
- Fit one piece at a time and compare each with the product photos and the pieces already in place.
These are general tips. Follow any instructions packed with your kit if they differ.
FAQ: TH24150 Rocker Panel Trim, Lower Kit
Where does TH24150 go?
From the bottom of the doors up 2.25".
Which Sienna years fit?
2004 through 2010.
How many pieces?
Eight.
Does it have a crease?
The listing says "With trim crease." See the photos.
How does it attach?
3M automotive-grade acrylic foam tape.
