Product Description
Honda Civic 1992-1995 Coupe Upper Rocker Kit TH92212, 3.75", 6 Pieces
The 1992-1995 Honda Civic 2-door coupe gets a six-piece polished stainless Upper Kit with TH92212. Coverage starts at the bottom of the molding and runs DOWN to the listed 3.75" width.
Coupe and sedan
QAA links the Civic sedan kit, TH92214, to this one:
- TH92212: coupe, 3.75", 6 pieces, no length note (this kit)
- TH92214: sedan, 4.5", 6 pieces, "between the wheel wells only"
Same piece count, different widths and bodies. Order the one tagged for your car.
The pillar set
The PP92214 Pillar Post Trim set (four pieces) is also linked, but it's tagged 4-door sedan. The record doesn't list it for the coupe, so check with us before putting it in a coupe order.
No length note
Unlike the sedan kit, this listing doesn't say whether coverage stops at the wheel wells. The photos show the layout; call 877-752-3811 if you need it confirmed.
A slim band
At 3.75" down from the molding, this is a narrow strip. Run masking tape 3.75" below the molding on both doors and step back to see where the lower edge will sit. A narrow strip shows any tilt clearly, so the dry fit is worth taking slowly.
Material
The Civic coupe pieces are made in the USA by QAA from polished 26 gauge 304 stainless steel and stick on over the existing finish with 3M automotive-grade acrylic foam tape. QAA says that tape will hold for a lifetime and won't damage the car's surface.
Molding condition
The top edge of each piece sits against the molding, so it needs to be straight and secure along both doors. Repair any loose section first.
Cleaning
- Wash below the molding and rinse
- Lift old wax off the coupe's doors with wax-and-grease remover
- Touch in chips or rust on the Civic
- An alcohol wipe on each panel as the final step
Six pieces
QAA lists no positions for these six. Use the photos to place them, and mark the liners as you go.
Dry fit and bond
Tape each piece up with its top edge snug under the molding. Sight along the side from both ends, then open the doors. Peel the liner a few inches at a time and press firmly.
Finishing the Civic set
Keep the Civic spacing consistent from piece to piece.
Conditions
Pick a shaded, mild, dry day, and keep the Civic unwashed overnight.
Ordering
Confirm the coupe and the year. Keep the box and liners until the job is done.
If the molding has been replaced
Because an Upper Kit follows the molding, its position decides where the lower edge ends up. If a molding on your coupe has been replaced or refitted, measure each door on its own and send us the figures with a photo before ordering.
One door first
Fit one door completely, step back, and check the lower edge from the front and rear before starting the other. Repositioning is easy while the liner is still on, and much harder once the tape has gripped the paint.
Civic coupe Upper Kit TH92212, UPC 691821578764 – QAA 877-752-3811.
TH92212 specifications
| Brand | QAA |
|---|---|
| Part number (MPN) | TH92212 |
| UPC | 691821578764 |
| Part type | Rocker Panel Trim, Upper Kit |
| Pieces in kit | 6 |
| Material | Polished 26-gauge 304 stainless steel |
| Finish | Polished to a mirror shine |
| Width | 3.75" |
| Coverage / notes | Spans from the bottom of the molding DOWN to the specified width |
| Mounting | 3M automotive-grade acrylic foam tape; installs directly over the existing surface |
| Origin | Made in the USA |
| Fits | 1992-1995 Honda Civic |
Fitment: TH92212
| Vehicle | Years | Body style |
|---|---|---|
| Honda Civic | 1992-1995 | 2-door, Coupe |
Fitment is listed exactly as QAA catalogs it. Confirm the body style as well as the year and model. Questions? Call Quality Automotive Trims at 877-752-3811 with your year, make, model, and body style.
Other QAA trim cataloged for the 1992-1995 Honda Civic
Check the body style on each listing; some kits are specific to one body style.
Installation tips: Rocker Panel Trim, Upper Kit
- Unpack all 6 pieces and match each one to its position on the vehicle, using the product photos, before fitting any of them.
- Each piece mounts with 3M automotive-grade acrylic foam tape, so clean and dry the mounting surface first; the tape needs paint or trim free of dirt and wax.
- Align the piece and press it firmly into place directly over the existing surface, working along its full length so the tape bonds evenly.
- Fit one piece at a time and compare each with the product photos and the pieces already in place.
These are general tips. Follow any instructions packed with your kit if they differ.
FAQ: TH92212 Rocker Panel Trim, Upper Kit
Which Civic does TH92212 fit?
The 1992-1995 Honda Civic 2-door coupe.
Where does it install?
From the bottom of the molding down 3.75".
Is there a sedan kit?
Yes, TH92214, a 6-piece Upper Kit at 4.5".
How many pieces?
Six.
