Product Description
Nissan Versa Sedan 2012-2019 Polished Stainless Window Sill Trim, 4 Pieces (WS12530)
Four strips of polished stainless steel make up WS12530, a Window Sill Trim Set listed for the Nissan Versa 4-door sedan from 2012 through 2019. The record gives no width for the strips, so the product photos are your reference for how much of each sill they cover.
Is this your Versa?
Only the sedan body appears on this listing. Hatchback owners, and anyone with a Versa built before 2012 or after 2019, should phone 877-752-3811 before buying rather than guess.
How the strips are made and held
Each piece is cut from high-quality 26 gauge 304 stainless, polished, and produced in the USA. On the car it rests over the existing surface of the sill and is bonded there by 3M automotive-grade acrylic foam tape. Per QAA, that tape is good for a lifetime of hold and leaves the vehicle's surface undamaged.
Which strip goes where
Four pieces arrive, but the record stops short of assigning them to particular doors. Spread them out next to the photos and pencil the door on each backing before anything else happens.
Matching Versa sedan parts
- Pillar posts: PP12530 (four pieces) or PP12531 (six pieces).
- Rocker choices: TH12530, a 1.25" pair fitted below the door; TH12531, a 1" lower kit with trim crease on the doors only; TH12532, a 1" upper kit that runs down from the bottom of the molding.
- WQ12530, a 0.875" wheel well accent.
- Rear of the car: a 1.5" rear deck accent, a rear bumper accent, an above-plate license bar and a license plate bezel; plus a gas door cover.
No window package is linked for the Versa, so sills and pillars are bought as separate sets.
Getting the sills ready
Run each glass panel up until it seals. A bucket of warm water with a little car shampoo and a microfibre pad is enough for the sill tops; squeeze the pad out well so water doesn't trickle down past the seal. Once dry, angle a torch along each sill and look for a waxy sheen, polish dust or a ridge of old adhesive. Scrape adhesive with plastic, never metal. A pass of wax-and-grease remover follows, and the isopropyl alcohol wipe waits until that strip is in your hand.
Placing each strip
The Versa job starts at one of the front doors. Rest the strip on the sill with its backing still attached and hold it with two bits of painter's tape, then check where both ends land compared with the photos. Satisfied? Lift the first few inches of backing at the rear end, press, and keep pulling the backing forward as you press behind it. Repeat at the other front door, then the two rear doors.
The first day
Give the bond a full day before the Versa sees a hose or a wash mitt, and avoid slamming the windows down hard in that time. After that, plain soap and a soft cloth keep the polish bright.
Fit problem or question about WS12530 (UPC 691821437160)? Quality Automotive Trims answers on 877-752-3811.
WS12530 specifications
| Brand | QAA |
|---|---|
| Part number (MPN) | WS12530 |
| UPC | 691821437160 |
| Part type | Window Sill Trim Set |
| Pieces in kit | 4 |
| Material | Polished 26-gauge 304 stainless steel |
| Finish | Polished to a mirror shine |
| Mounting | 3M automotive-grade acrylic foam tape; installs directly over the existing surface |
| Origin | Made in the USA |
| Fits | 2012-2019 Nissan Versa |
Fitment: WS12530
| Vehicle | Years | Body style |
|---|---|---|
| Nissan Versa | 2012-2019 | 4-door, Sedan |
Match the year, model, and body style in this table to your vehicle before ordering. Questions? Call Quality Automotive Trims at 877-752-3811 with your year, make, model, and body style.
Other QAA trim cataloged for the 2012-2019 Nissan Versa
- GC12530: 1-piece Gas Door Cover Trim
- LB12530: 1-piece License Bar, Above plate accent Trim
- LP12530: 1-piece License Plate Bezel
- PP12530: 4-piece Pillar Post Trim
- PP12531: 6-piece Pillar Post Trim
- RB12530: 1-piece Rear Bumper Trim Accent
- RD12530: 1-piece Rear Deck Accent
- TH12530: 2-piece Rocker Panel Trim, On the rocker
Check the body style on each listing; some kits are specific to one body style.
Installation tips: Window Sill Trim Set
- Unpack all 4 pieces and match each one to its position on the vehicle, using the product photos, before fitting any of them.
- Each piece mounts with 3M automotive-grade acrylic foam tape, so clean and dry the mounting surface first; the tape needs paint or trim free of dirt and wax.
- Align the piece and press it firmly into place directly over the existing surface, working along its full length so the tape bonds evenly.
- Fit one piece at a time and compare each with the product photos and the pieces already in place.
These are general tips. Follow any instructions packed with your kit if they differ.
FAQ: WS12530 Window Sill Trim Set
Does WS12530 fit the Versa hatchback?
It's listed for the 2012-2019 Versa 4-door sedan. Hatchback owners should call 877-752-3811.
How wide are the strips?
The record doesn't list a width; see the photos.
Is there a Versa window package?
None is linked; PP12530 & PP12531 are the pillar sets.
How many pieces come in the set?
Four.
